Siemens SINAMICS S120 Combi - Page 200

Electrically connecting Motor Modules and DC link components
8.4 Connecting an additional component
200
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
3. Install the lower and upper DC link busbars.
Install the lower DC link busbar
Install the upper DC link busbar
• Release the screws.
• Turn over the DC link bridge.
• Observe the following sequence when
screwing into place.
• Release the screws.
• Turn over the DC link bridge.
• Observe the following sequence when
screwing into place.
Screwdriver
Torx T20 or slotted 1.2 x 6
Tightening torque
1.8 Nm
4. Install the 24 V connector (accessories pack of the component to be connected).
Figure 8-4 Motor Modules with 24 V connector installed
5. Close the protective covers of both components.