iii
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Preface
SINUMERIK documentation
The SINUMERIK documentation is organized in 3 parts:
S General Documentation
S User Documentation
S Manufacturer/service documentation
For more detailed information on SINUMERIK 802D sl and other publications covering all
SINUMERIK controls (e.g. universal interface, measuring cycles...), please contact your local
Siemens office.
A list of documents, updated on a monthly basis, is available on the Internet for the available
languages at:
http://www.siemens.com/motioncontrol
Select “Support”/“Technical Documentation”/“Overview of Documents”.
The Internet version of the DOConCD (DOConWEB) is available at:
http://www.automation.siemens.com/doconweb
Target readership of this documentation
This document is designed for machine tool manufacturers. The present documentation pro-
vides all information required by the manufacturer to start up the SINUMERIK 802D sl CNC.
Standard scope
This Instruction Manual describes the functionality of the standard scope. Additions or revi-
sions made by the machine tool manufacturer are documented by the machine tool manufac-
turer.
Other functions not described in this documentation might be executable in the control. This
does not, however, represent an obligation to supply such functions with a new control or
when servicing.
Hotline
If you have any questions, please contact the following hotline:
A&D Technical Support
Phone: +49 (0) 180 / 5050 - 222
Fax: +49 (0) 180 / 5050 - 223
Internet: http://www.siemens.com/automation/support-request
If you have any comments, suggestions, or corrections regarding this documentation, please
fax or e-mail them to:
Fax: +49 (0) 9131 / 98 - 63315
E-mail: motioncontrol.docu@siemens.com
Fax form: See the reply form at the end of the document.
To Next Page
Loading...
Need help?
General
