Setup
3.4 Programming the setting data
3-42
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Softkeys
The working area limitation is active with geometry and additional axes. Enter the values for
the work area limitation. Selecting the <Set active> softkey enables / disables the values for
the axis highlighted by the cursor.
Fig. 3-9
Timers Counters
Fig. 3-10
Explanation:
S Total parts: Number of workpieces produced in total (total actual value)
S Parts requested: Number of workpieces required (number of workpieces setpoint)
S Number of parts: This counter registers the number of all workpieces produced since the
starting time.
S Total runtime: Total execution time of NC programs in the Automatic mode ( in seconds ):
In the AUTOMATIC mode, the execution times of all programs are summed between NC
start and program end / reset. The timer is zeroed with each power-up of the control sy-
stem. Time of execution of the selected NC program (in seconds)
Set
active
Times
Counters
To Next Page
Loading...
