Siemens SINUMERIK 802D sl Operation And Programming Manual

AUTOMATIC Mode
5-56
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Program
control
Program
test
To
contour
Dry run
feedrate
Conditional
stop
Skip
Single block
fine
RTO (rap. trav.
overr.) eff.
Previous<<
Previous<<
Find
To
end point
Without
calcul.
Interr.
Program
correction
Block
search
Fig. 5-2 The AUTOMATIC menu tree
Parameters
Table 5-1 Description of the parameters in the working window
Parameter
Explanation
MCS
X
Y
Displays the existing axes in the MCS or WCS
+ X
– Y
If you traverse an axis in the positive (+) or negative () direction, a plus or minus sign will appear in
the relevant field.
If the axis is already in the required position, no sign is displayed.
Position
mm
These fields display the current position of the axes in the MCS or WCS.
Distance-
to-go
These fields display the current position of the axes in the MCS or WCS.
G function Displays important G functions
Feed F
mm/min
Displays the path feedrate actual value and setpoint
Tool Displays the currently active tool with the current edge number (T..., D...).
Current block The block display displays seven subsequent blocks of the currently active part program. The dis-
play of one block is limited to the width of the window. If several blocks are executed quickly one
after the other, it is recommended to switch to the “Program progress” window. To switch back to the
seven-block display, use the “Program sequence” softkey.
Softkeys
The program control softkeys are displayed (e.g. “Skip block”, “Program test”).
Program
control

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English