System
7-92
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Time base
Time of marker position Time difference between
marker 1 and current
marker position
Fig. 7-18 Meaning of the fields
Use this menu to parameterize the measuring channel.
Fig. 7-19
S Selecting the axis: To select the axis, use the “Axis” toggle field.
S Signal type:
Following error
System deviation
Contour deviation
Actual position value
Speed actual value
Speed setpoint
Compensation value
Set of parameters
Controller input position setpoint
Controller input speed setpoint
Controller input acceleration setpoint
Speed forward control value
Exact stop fine signal
Exact stop coarse signal
S Status: On The recording is performed in this channel.
Off The channel is inactive.
The parameters for the measuring time and for the trigger type for channel 1 can be set in
the lower screen half. The remaining channels will accept this setting.
S Determining the measuring time: The measuring time in ms is entered directly in the
“Measuring time” input field. It applies to all trace channels.
Select
signal
To Next Page
Loading...
