Siemens SIPROTEC 7SJ62 - Page 532

Index
Index-2 7SJ62 Instruction Manual
C53000-G1140-C121-1
Configuration Matrix 4-7, 4-21, 5-11
Configuration of Functions 5-2
Configuration of Inputs and Outputs 4-21
Configuring
an Indication Buffer as a Destination 5-26
Binary Inputs as Sources 5-21
Binary Outputs as a Destination 5-23
CFC as a Destination 5-27
CFC as a Source 5-23
Control Display as a Destination for
Command Initiation 5-27
Default Display and Control Diagram as a
Destination 5-27
Measured Value Window as a Destination 5-
27
Metered Value Window as a Destination 5-27
SCADA Interface as a Destination 5-26
Connection Examples A-11
Connections 8-4, 8-15
Consistency check 5-36
Construction 10-10
Control 4-14
Control Functions 1-5
Control Messages 7-48
Control of Device Functions 7-28
Control of Switchgear 7-38
Control Voltages for Binary Inputs 8-7
Corrective Action 9-9
Covering Caps 2-8, A-4
Cross Blocking 6-69
CT’s Nominal Values 6-9
CT’s Ratios 6-9
Cubicle Mounting 2-2, A-6
Current and Voltage Rotation 6-151
Current Flow Monitoring 6-10
Current Inputs 10-2
Current Supervision 6-117
Current Symmetry 6-150
Current Terminals 2-7
Cyclical Restoration 5-29
D
Date and Time 7-28
Date and Time Setting 3-12
Date and Time Stamping 5-44
Default Settings A-69
Definite Time Elements (46-1, 46-2) 6-86
Definite Time, Directional Overcurrent Protection
6-42
Definite-Time Overcurrent Protection 10-11
Deleting Groups and Information 5-20
Destination 5-14
Determination of Direction 6-45, 6-74
Determination of the Phase with a Ground
Connection 6-79
DIGRA A-5
DIGSI REMOTE 4 A-5
DIGSI® 4 Tool 4-7
Dimensions 10-40
Directional Testing With Load Current 8-20
Directional Time Overcurrent Protection 1-8, 6-
40, 10-18
Directional Time-Overcurrent Ground Protection
6-57
Directional Time-Overcurrent Phase Protection 6-
49
Directional Torque Angle 6-80
Disassembling the Device 9-9
Display 4-6
Display Contrast 3-6
Display Contrast Setting 3-6
Display Editor A-5
DNP3.0 4-3
Double Point Indication (DP) 5-16
Dynamic Blocking 6-132, 6-135
Dynamic Cold Load Pick-up Function 6-62, 10-
19
Dynamic Cold Load Setting Adjustment 1-8
E
Electrical Check 3-3
Electrical Communication Interfaces 2-13
Electrical Tests 10-6
Elementary Diagrams A-6
EMC Tests for Immunity 10-7
EMC Tests For Noise Emission 10-8
Emergency Starting 6-104
Energy 7-21
Entering Your Own Information 5-19
Establishing Information Properties 5-14
Event Log 3-6, 3-11, 7-4
Event Messages 3-6, 3-11
Extending the Time Constants 6-107
Extension of Time Constants 6-104
F
Fault Location 6-143, 10-35
Fault Locator 6-146
Femal Plug A-4
www . ElectricalPartManuals . com