The SINAUT Configuration Tool
6.4 The connection configuration
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
145
Figure 6-2 Example of a DNP3 connection between DNP3 master station and DNP3 station
The connection shown in red in the figure between the DNP3 master station and DNP3
station is not shown in this form in NetPro.
This is taken into account in the SINAUT connection configuration:
● Connections can be configured without knowing the exact connection path.
● The exact connection path can be viewed based on a list of used network nodes. The
degree of detail of the connection information can be set.
View of the Connection Configuration window
Open the connection configuration only after the configuration in STEP 7 NetPro has been
completed.
After opening the connection configuration, the configuration window opens.
To Next Page
Loading...
