Siemens VDO DTCO 1381 - Page 298

Service only
14.4 Explanation of printout examples Appendix
14 - 28
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
Time settings
Listing of all available data about time setting (in data sets)
• Date and time, old
• Date and time, changed
• Name of workshop that set the time
• Address of workshop
• Workshop identification
• Workshop card valid until ...
Remark
In the second data set it can be seen that the UTC time was corrected by an authorized
workshop.
The most recently recorded event and the current fault
•  = Most recent event, date, and time.
• Y = Most recent fault, date, and time.
Information on overspeeding control
• Date and time of the most recent control.
• Date and time of the first instance of overspeeding since the most recent control and
the number of subsequent overspeeding instances.
First instance of overspeeding since the most recent calibration
The five most severe instances of overspeeding of the last 365 days
The most severe instances of overspeeding on the 10 most recent days of
appearance
Entries during instances of overspeeding (chronologically arranged by highest
average speed)
• Date, time, and duration of overspeeding
• Highest and average speed of the overspeeding instance, number of similar events on
this day
• Last name of driver
• First name of driver
• Card identification of the driver
Remark
If no data set for an instance of overspeeding appears in a block, then the following
appears: "ww".
Pos. / block Data block specification / explanation
17
17a
17b
18
19
20
20a
20b
20c