EasyManua.ls Logo

SimCom SIM5350

SimCom SIM5350
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIM5350 AT Command Set
AT+CLCC=<n>
OK
Execution Command Responses
+CLCC:<id1>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]][<CR><LF>
+CLCC:<id2>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]]
[...]]
OK
ERROR
AT+CLCC
+CME ERROR: <err>
Defined values
<n>
0 Don’t report a list of current calls of ME automatically when the current call status changes.
1 Report a list of current calls of ME automatically when the current call status changes.
<idX>
Integer type, call identification number, this number can be used in +CHLD command operations.
<dir>
0 – mobile originated (MO) call
1 – mobile terminated (MT) call
<stat>
State of the call:
0 – active
1 – held
2 – dialing (MO call)
3 – alerting (MO call)
4 – incoming (MT call)
5 – waiting (MT call)
<mode>
bearer/teleservice:
0 – voice
1 – data
3 – voice followed by data, voice mode
4 – alternating voice/data, voice mode
6 voice followed by data, data mode
7 – alternating voice/data, data mode
9 – unknown
<mpty>
0 call is not one of multiparty (conference) call parties
1 call is one of multiparty (conference) call parties
<number>
SIM5350_ATC_V1.02 6/9/2014
32

Table of Contents

Related product manuals