SimCom SIM7000 Series At Command Manual

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 113 2018-05-08
IP Internet Protocol (IETF STD 5)
PPP Point to Point Protocol
IPV6 Internet Protocol Version 6
IPV4V6 Dual PDN Stack
<APN> (Access Point Name) A string parameter (string should be
included in quotation marks) which is a logical name that
is used to select the GGSN or the external packet data
network. If the value is null or omitted, then the
subscription value will be requested.The default value is
NULL.
<PDP_addr> A string parameter that identifies the MT in the address
space applicable to the PDP.
Format: "<n>.<n>.<n>.<n>" where <n>=0..255
If the value is null or equals 0.0.0.0 a dynamic address will
be requested. The allocated address may be read using the
+CGPADDR command.
<d_comp> A numeric parameter that controls PDP data compression
0 Off (default if value is omitted)
1 On
2 V.42bis
<h_comp> A numeric parameter that controls PDP head compression
0 Off (default if value is omitted)
1 On
2 RFC1144
3 RFC2507
4 RFC3095
<ipv4_ctrl> Parameter that controls how the MT/TA requests to get the
IPv4 address information:
0 Address Allocation through NAS Signaling
1 on
<emergency_flag> Emergency_flag:
0 Off (default if value is omitted)
1 On
Parameter Saving
Mode
AUTO_SAVE
Max R
esponse
Time
-
Reference Note
<cid> values 17 to 24 are supported from MPSS JO 1.0+ onwards.
6.2.3 AT+CGACT PDP Context Activate or Deactivate
AT+CGACT PDP Context Activate or Deactivate
Test Command Response
SIMCOM COMFIDENTIAL FILE

SimCom SIM7000 Series Specifications

General

Brand	SimCom
Model	SIM7000 Series
Category	Control Unit
Language	English