SimCom SIM7000 Series At Command Manual

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 164 2018-05-08
Read Command
AT+CIPCTL?
Response
+CIPCTL: <mode>
OK
Parameters
See Write Command
Write Command
AT+CIPCTL=<mod
e>
Response
OK
or
ERROR
or
+CME ERROR: <err>
Parameters
<mode> 0 Disable to send Echo Reply
1 Enable to send Echo Reply to every IP address
pinging it
2 Enable to send Echo Reply only to a subset of IP
Addresses pinging it. This subset of IP Addresses
can be set by "AT+CIPFLT" command.
Parameter Saving
Mode
NO_SAVE
Max Response Time -
Reference Note
The value of <mode> is stored in non volatile memory.
10.2.3 AT+CIPFLT Set the Rules of IP Filter
AT+CIPFLT Set the Rules of IP Filter
Test Command
AT+CIPFLT=?
Response
+CIPFLT: (list of supported <action>s),(list of supported <item>s)
OK
Parameter
See Write Command
Read Command
AT+CIPFLT?
Response
+CIPFLT: <item>,<ipAddr>,<mask>
[<CR><LF>+CIPFLT: <item>,<ipAddr>,<mask>
[…]]
OK
Parameter
See Write Command
SIMCOM COMFIDENTIAL FILE

SimCom SIM7000 Series Specifications

General

Brand	SimCom
Model	SIM7000 Series
Category	Control Unit
Language	English