Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 17 2018-05-08
2 AT Commands According to V.25TER
These AT Commands are designed according to the ITU-T (International Telecommunication
Union, Telecommunication sector) V.25ter document.
2.1 Overview of AT Commands According to V.25TER
A/
Re-issues the last command given
ATD Mobile originated call to dial a number
ATE Set command echo mode
ATH Disconnect existing connection
ATI Display product identification information
Set monitor speaker loudness
ATM Set monitor speaker mode
Switch from data mode or ppp online mode to command mode
ATO Switch from command mode to data mode
ATQ Set result code presentation mode
ATS0 Set number of rings before automatically answering the call
ATS3 Set command line termination character
Set response formatting character
Set command line editing character
ATS6 Pause before blind dialling
ATS7 Set number of seconds to wait for connection completion
ATS8 Set number of seconds to wait for comma dial modifie
r encountered in
dial string of D command
Set disconnect delay after indicating the absence of data carrier
ATV TA response format
ATX Set connect result code format and monitor call progress
ATZ Reset default configuration
AT&C Set DCD function mode
Factory defined configuration
AT&V Display current configuration
AT&E Set CONNECT Result Code Format About Speed
AT+GCAP Request complete TA capabilities list
To Next Page
Loading...
Need help?
General
