SimCom SIM7000 Series At Command Manual

Smart Machine Smart Decision
SIM7000 Series_AT Command Manual_V1.03 74 2018-05-08
<mem3>,<used3>,<total3>
OK
ERROR
Parameters
See Write Command
Write Command
AT+CPMS=<me
m1>[,<mem2>[,<
mem3>]]
Response
TA selects memory storages <mem1>,<
mem2> and <mem3> to be used for
reading, writing, etc.
+CPMS: <used1>,<total1>,<used2>,<total2>,<used3>,<total3>
OK
ERROR
Parameters
<mem1> Messages to be read and deleted from this memory storage
"SM" SIM message storage
<mem2> Messages will be written and sent to this memory storage
"SM" SIM message storage
<mem3> Received messages will be placed in this memory storage if
routing to PC is not set ("+CNMI")
"SM" SIM message storage
<usedx> Integer type; Number of messages currently in <memx>
<totalx> Integer type; Number of messages storable in <memx>
Parame
ter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference
3GPP TS 27.005
Note
4.2.10 AT+CRES Restore SMS Settings
AT+CRES Restore SMS Settings
Test Command
AT+CRES=?
Response
+CRES: list of supported <profile>s
OK
Parameter
See Write Command
Write Command
AT+CRES=<pro
file>
Response
Execution command restores message service settings from non-
volatile
memory to active memory. A TA can contain several profiles of settings.
Settings specified in commands Service Centre Address +CSCA and
Set
SIMCOM COMFIDENTIAL FILE

SimCom SIM7000 Series Specifications

General

Brand	SimCom
Model	SIM7000 Series
Category	Control Unit
Language	English