Simex multicon cmc-99 - 7.8.1. Logical Channels - General

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
–
Latch
parameter block - allows the user to set the
latch function
which will hold the
last value of a channel (discussed in
Chapter 7.8.1. Logical Channels - General
settings
),
–
Processing
parameter block - is used for scaling and filtering data (discussed in
Chapter 7.8.1. Logical Channels - General settings
),
–
Displaying
parameter block - for these parameters the user select format and range
of data displayed on the screen (discussed in
Chapter 7.8.1. Logical Channels -
General settings
),
User must configure the Profile/timer parameters in the
Profiles/timers
menu
before using this Profile/timer to control real object (To read more about
Profiles/timers
profiles see
Chapter 7.12. PROFILES/TIMERS
).
Configure source
button in
Profile/timer
menu
There are two methods for configuring Profiles/timers:
– by the
Profiles/timers
menu, following steps:
MAIN->Device configuration->
Profiles/timers
(see
Chapter 7.12. PROFILES/TIMERS
),
– directly in the
Logical channel
in
Profile/timer
mode by pressing the
Configure source
button.
View of window of configuration the profile/timer in both cases is the same. Overview of
setting profile/timer is presented in
Chapter 7.12. PROFILES/TIMERS
.
108
i