Simex multicon cmc-99 - Available modules

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
– If the
UN3
or
UN5
module is installed, the +24V DC output is available only in
devices equipped with
PS42
power supply module. In other cases there is
no +24V DC output
available and these terminals remain disconnected.
Depending on customer's needs, the basic version of the device can be upgraded with up to:
– three I / O modules (installed in a place designated as
Slot A
,
Slot B
,
Slot C
),
– advanced communication module (additional serial, USB and Ethernet interfaces
installed in
Slot D
).
According to the order these terminals can look different than shown in
Fig. 4.8
or be not
present. Terminals and connections of available modules are shown in
Fig. 4.9
÷
Fig. 4.21
in
Section 4.3.1.
.
Shown below is an example of a configuration of the installed modules:
– base,
– Slot A - UI8 module (8 current input & 8 voltage input),
– Slot B - RT4 module (4 RTD input),
– Slot C - R81 module (8 relay output 1A/250V),
– Slot D - ACM module (additional serial, USB and Ethernet interfaces).
4.3.1. Available modules
Fig. 4.9. Voltage and current input modules
17
i
U16
16 voltage inputs
n08
n09
n10
n11
n12
n04
n05
n06
n07
n01
n02
n03
n20
n16
n17
n18
n19
n13
n14
n15
GND
IN9
IN10
IN11
IN12
4 x 0-10V
GND
IN13
IN14
IN15
IN16
4 x 0-10V
GND
IN1
IN2
IN3
IN4
4 x 0-10V
GND
IN5
IN6
IN7
IN8
4 x 0-10V
I16
16 current inputs
n08
n09
n10
n11
n12
n04
n05
n06
n07
n01
n02
n03
n20
n16
n17
n18
n19
n13
n14
n15
GND
IN1
IN2
IN3
IN4
4 x 0-20mA
GND
IN5
IN6
IN7
IN8
4 x 0-20mA
GND
IN9
IN10
IN11
IN12
4 x 0-20mA
GND
IN13
IN14
IN15
IN16
4 x 0-20mA
UI4
4 current
+ 4 voltage inputs
n08
n09
n10
n04
n05
n06
n07
n01
n02
n03
GND
IN1
IN2
IN3
IN4
4 x 0-20mA
GND
IN5
IN6
IN7
IN8
4 x 0-10V
UI8
8 current
+ 8 voltage inputs
n08
n09
n10
n11
n12
n04
n05
n06
n07
n01
n02
n03
n20
n16
n17
n18
n19
n13
n14
n15
GND
IN1
IN2
IN3
IN4
4 x 0-20mA
GND
IN5
IN6
IN7
IN8
4 x 0-20mA
GND
IN9
IN10
IN11
IN12
4 x 0-10V
GND
IN13
IN14
IN15
IN16
4 x 0-10V