Simex multicon cmc-99 User Manual

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.11. EXTERNAL OUTPUTS
The
External outputs
menu is related to sending the date to SLAVE device using
Modbus communication protocol. In this menu it is determined what data will be send to
SLAVE device while the configuration of Modbus in Master mode (for example baud rate,
define the SLAVE device, active output register list and etc.) is defined in the
Modbus
menu
(see
Chapter 7.15.3. Modbus - MASTER mode
).
7.11.1. External outputs - General settings
In the device there are as many external outputs as will be defined in the
Modbus
menu
(see
Chapter 7.15.3. Modbus - MASTER mode
). In case when the external outputs are not
defined or inactive than in
External outputs
menu is an empty list.
External outputs can have a control type (control type setting, see
Chapter 7.15.3.2. Modbus
MASTER - Device channels parameter block
):
–
as a relay
,
–
as a linear output
,
View of
External outputs
menu is created for two types of control: as a relay (digital output)
and a linear output (analogue output) is shown in
Fig. 7.93
and
Fig. 7.94
, respectively.
165
Device configuration
MENU
General settings
Logical channels
Built-in inputs
Built-in outputs
External outputs
Profiles/timers
Controllers
Groups
Modbus
Network settings
Access options
Printouts
Notifications

Simex multicon cmc-99 Specifications

General

Brand	Simex
Model	multicon cmc-99
Category	Controller
Language	English