Simex multicon cmc-99 - Page 166

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
Fig. 7.93. View of External outputs menu for 'as a relay' type control
Fig. 7.94. View of External outputs menu for 'as a linear output' type control
Arrows placed in the upper right corner of the screen let you switch
between a succession of external outputs. The middle button allows
direct selection of a specific external output from the list.
The parameters that are common for the
External
outputs (see
Fig. 7.93
and
Fig. 7.94
) are:
–
Communication port
- this parameter is read only in
External outputs
menu, and
indicates the Modbus port number, a description of Modbus ports configuration and
view of the Modbus port connectors is located in
Chapter 7.15. MODBUS
,
–
Device
- this parameter is read only in
External outputs
menu, it shows address
and name of the SLAVE device configured in Modbus menu (
Chapter 7.15.3.
Modbus - MASTER mode
),
–
Output channel
- this parameter is read only in
External outputs
menu, it shows
output channel number, type of register and data format configured in Modbus menu
(each SLAVE device defined in a specific address, has its individually numbered
output list),
–
Source
– this parameter allows to choose a source for external output from logical
channel list (see
Fig. 7.95
),
166
Modbus port number
SLAVE device address
The register number of SLAVE device
(HR-HOLDING Register)
Relay mode
The name of SLAVE device
Data format
External output number
Output channel number
1
2
3
5
1