User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.7. GENERAL SETTINGS
The
General settings
menu allows to configure user interface display settings, the default
screen when the device powers on and automatic view change settings.
The parameters of the
General settings
menu are:
–
Basic
parameter block – this block includes two parameters:
•
Language
- this parameter allows the user to select the language, available
languages are: English, Polish, Spanish, German, Russian, French, Czech,
Romanian and Hungarian.
•
Date and time
- this parameter allows the user to set the current date and time,
•
Time zone
– parameter which should contain time zone where the device works
which allows to properly correct date and time in the device,
•
Reg. num. displaying
- this parameter allows to change mode of displaying the
Register addresses for
Logical channel
and
External output
menu. Two
formats are available:
◦
hexadecimal
- the registers are displayed in hexadecimal format. To
indicate that data has a hexadecimal format, the letter '
h
' is added at the
end - for example, 12h (0x12),
◦
decimal
- the registers are displayed in decimal format (without any marker)
e.g. 123
–
LCD screen
parameter block:
•
Backlight
- this parameter allows the user to set the level of the LCD backlight.
Available levels are:
20%
(least backlight),
40%
,
60%
,
80%
,
100%
(the most
backlight),
–
Screen saver
parameter block - these parameters can reduce backlight level of the
LCD screen (or make it completely blank) during normal operation, i.e. when the
user does not touch the screen for a set time. This block has two parameters:
•
Mode
- this parameter has the following options:
63
Device configuration
MENU
General settings
Logical channels
Built-in inputs
Built-in outputs
External outputs
Profiles/timers
Controllers
Groups
Modbus
Network settings
Access options
Printouts
Notifications
To Next Page
Loading...
Need help?
General
