Simex multicon cmc-99 User Manual

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
–
Shape
parameter set as
slope
,
– in
Final value
parameter write
10
,
◦ press green button on the bottom left side of the screen,
◦
Section num.
parameter should be set as
2
,
– in
Duration
parameter write
2
,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
const.value
,
– in
Final value
parameter write
8
,
◦ press green button on the bottom left side of the screen,
◦
Section num.
parameter should be set as
3
,
– in
Duration
parameter write
3
,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
slope
,
– in
Final value
parameter write
4
,
◦ press green button on the bottom left side of the screen,
◦
Section num.
parameter should be set as
4
,
– in
Duration
parameter write
1
,
–
Unit
parameter set as
second
,
–
Shape
parameter set as
const.value
,
– in
Final value
parameter write
4
,
•
Looping
parameter set as
disabled
,
– for
Displaying
block parameters:
•
Format
parameter set as
numeric
,
•
Precision
parameter set as
0.0
,
• in
Graph low
write
0
,
• in
Graph high
write
10
,
Configuration of logical channel 2 (Triggering source) in
Hardware input
mode for
current input
is shown in
7.8.11.1. Application of Logical channel in the Hardware input
mode for UI4 module
(for this mode we configure logical channel 2 in this task).
Second method is shown in
7.12.4.1. Application of the Profiles/timers
.
134

Simex multicon cmc-99 Specifications

General

Brand	Simex
Model	multicon cmc-99
Category	Controller
Language	English