Simex multicon cmc-99 User Manual

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
–
Server port
– parameter allowing to set web server port number where internet
service works. Allows to connect with the device using web browser on selected port.
It is also needed while configuring remote connection with the device which is
outside local network. It is not recommended to set number ports which are reserved
to standard services.
–
NTP server address
– parameter which allows to set NTP server address, download
actual time from it and, if necessary, correct device's system clock displaying. The
device will connect to NTP server every 15 minutes and correct it’s time according to
downloaded server time.
If
DHCP
parameter is set as
disabled
the parameters
IP address
and
Subnet mask
must be configured correctly, depending on the local network settings
which will work with the device. User should contact with network administrator in
case of errors in communication.
The actual network settings are visible in the
Device Information
menu (see
Chapter 7.4.
).
To establish connection between the device and PC, port number 6000 must be
unlocked in software and hardware firewall.
To establish connection between MultiCon and other device using TCP/IP protocol,
port number 502 must be unlocked in software and hardware firewall.
To connect MultiCon with other device using HTTP protocol, port number 80 must be
unlocked in software and hardware firewall.
224
i
i
i
i

Simex multicon cmc-99 Specifications

General

Brand	Simex
Model	multicon cmc-99
Category	Controller
Language	English