1. Safety instructions
1.7 Intended use 1.8 Foreseeable misuse
Any usage of the product differing from the
aforementioned conditions and stated
purpose is strictly prohibited.
Particularly prohibited are:
o Use for other control tasks
o Use in an explosion protection zone
o Use to feed, forward, or store hazardous
substances and mixtures as defined in
Annex I Part 2-5 of the CLP Regulation
(EC 1272/2008)
o Use to feed / forward / store gases, lique-
fied gases, dissolved gases, vapors, or
fluids whose vapor pressure exceeds nor-
mal atmospheric pressure (1013 mbar)
by more than 0.5 bar at their maximum
permissible operating temperature
The Lubrication Monitor Controller is used
to control up to three pumps, each with
one to three zones (one to three main lines)
in SKF Dual Line centralized lubrication
systems.
LMC 301 designs 086501 and 086503
(IO module) are powered via 110/230 VAC
mains provided by the customer. They must
be connected according to DIN and VDE
regulations.
LMC 301 designs 086500 and 086502 (IO
module) are powered via 24 VDC.
The technical information contained in this
manual must be observed.
Any other usage is deemed non-compliant
with the intended use.
ENEN
o Fuses must not be bridged. Always re-
place fuses with fuses of the same type.
o Ensure proper grounding of the product.
o Drill holes required for assembly only on
non-critical, non-load-bearing parts.
o Other units of the machine/the vehicle
must not be damaged or their function
impaired by the installation.
o No parts of the centralized lubrication
system may be subjected to torsion,
shear, or bending.
o Use suitable lifting gear when working
with heavy parts.
o Avoid mixing up/incorrectly assembling
disassembled parts. Label parts.
11
1
To Next Page
Loading...
Need help?
General
