1. Safety instructions
ENEN
1.12 Residual risks
Table 1
Residual risk Remedy
Life cycle: Assembly/commissioning/operation/setup and retrofit
Electric shock due to defective or incor-
rectly connected power lead for power
supply or load relay
• Inspect the power lead for damage before starting the product
• Correctly wire/connect the power lead
Tearing/damage to lines when installed on
moving machine components
• Flexible cable lines must be used if installing on moving parts
Life cycle: Malfunction, troubleshooting, maintenance, repair/decommissioning and disposal
Electric shock due to defective power lead
for power supply
• Inspect the power lead for damage before starting the product
Electric shock from open control cabinet
or active energized components
• Disconnect the customer-provided main switch or mains plug (cut power) before performing
any work on electrical components
• Exercise caution when operating the product
13
1
To Next Page
Loading...
Need help?
General
