7. Operation/decommissioning and disposal
7. Operation/decommissioning and disposal
Dual Line centralized lubrication systems
with
LMC 301 Controller typically operate
automatically.
If the LMC 301 Controller is enabled (green
POWER LED is lit), the display shows the
current lubrication routine.
Any saved error messages can be read by
pressing arrow key down.
Errors must be resolved immediately!
Lubricant transport in the lubrication lines
and the lubricant fill level in the lubricant
reservoir must be subjected to regular visual
inspection.
Top up the lubricant if the fill level is too low.
)Explanation of display symbols and
controls - see Chapter 63.2.
IMPORTANT NOTE
The description of the main menu is based
on the setting options that the end
customer can adjust.
7.1 User-configurable setting options
The main menu shows the following
options:
Login settings
)See Chapter 6.3.7
The <Login settings> menu is used to
manage access to the menus with a
password. The password can also be
changed here.
User settings
)See Chapter 6.3.6
In this menu, the measurement units
(metric or inch) and the language for the
user menu can be selected.
Main menu, Fig. 29
Main menu
Login settings
User settings
Device settings
Pump 1 Timings
Information
Back
OK
The customer can access the menus stored
in the Main menu (see Fig. 29) and make
some settings. The procedure is described in
Chapters 6.3.6 and 6.3.12.
IMPORTANT NOTE
When saving data, make sure to press
Save control key for at least three seconds.
To Next Page
Loading...
Need help?
General
