SKF LMC 301 series User Manual

1. Safety instructions
ENEN
1.9 Disclaimer of liability
The manufacturer shall not be held liable for
damage resulting from:
o Failure to comply with these instructions
o The use of lubricants/media not approved
for the unit type
o Contaminated or unsuitable lubricants
o Installation of non-original SKF
components
o Non-compliant usage
o
Improper assembly, configuration or filling
o Improper reaction to malfunctions
o
Non-observance of maintenance intervals
o Independent modification of system
components
1.10 Referenced documents
In addition to this manual, the following
documents must be observed by the
respective target group:
o Operational instructions / approval rules
o Instructions from suppliers of purchased
parts
o Manual for the insulation resistance tester
o Project planning documents and other
relevant documents
The operator must supplement these docu-
ments with applicable regulations for the
country of use.The documentation must be
included if the product is transferred to a
new operator.
1.11 Warning labels on the product
The following warning labels are affixed to
the product. Before commissioning, check
that the labels are present and intact.
Immediately replace warning labels if
damaged or missing. The product must not
be operated until then. See the positioning
diagram for the order number and position
on the product.
Positioning of warning labels, Fig. 1
Order No. : 246-078-289
Order No. : 44-1826-3122
12

SKF LMC 301 series Specifications

General

Brand	SKF
Model	LMC 301 series
Category	Controller
Language	English