SKF LMC 301 series User Manual

6. Configuration by operator/local admin
6.3.5 Main menu
The main menu shows the following
options:
Login settings
)See Chapter 6.3.7
The <Login settings> menu is used to
manage access to the menus with a pass-
word. The password can also be changed
here.
Setting options for operators without
password access
)See Chapter 6.3.6
In this menu, the measurement units (met-
ric or inch) and the language for the user
menu can be selected.
Device settings
)See Chapter 6.3.8
In this menu, the display properties of the
screen, such as backlight or contrast, can
be modified. The date and time are also set
here.
Main menu, Fig. 246
Pump 1 Timings
)See Chapter 6.3.9
The timing of the pump and the settings
for the associated main line are performed
here. Up to three pumps can be activated,
each with up to three zones (zone1 to
zone3).
Information
)See Chapter 6.3.12
The hardware and firmware versions
are stored in this menu. The hours of
controller operation, the error history, and
the serial number of the controller unit can
also be viewed here.
Further, the total lubrication cycles for each
pump and zone are shown here (example
pump 1, zone 1=>P1Z1).
Main menu
Login settings
User settings
Device settings
Pump 1 Timings
Information
Back
OK
EN
50
IMPORTANT NOTE
The description of the main menu is based
on settings that the end customer can
adjust.
(password level Set PW local admin)

SKF LMC 301 series Specifications

General

Brand	SKF
Model	LMC 301 series
Category	Controller
Language	English