5. Assembly
IMPORTANT NOTE
Observe the technical data (Chapter 3).
EN
28
5. Assembly
Only qualified technical personnel may
install, operate, maintain, and repair the
LMC 301 Lubrication Monitor Controller.
Qualified technical personnel are persons
who have been trained, assigned, and
instructed by the operator of the final
product into which the described Lubri-
cation Monitor Controller is incorporated.
Such persons are familiar with the rel-
evant standards, rules, accident preven-
tion regulations, and operating conditions
as a result of their training, experience,
and instruction. They are qualified to
carry out the required activities and in
doing so recognize and avoid potential
hazards.
The definition of qualified personnel and
the prohibition against employing non-
qualified personnel are laid down in DIN
VDE 0105 and IEC 364.
Before assembling/setting up the Lubrication
Monitor Controller, the packaging material
and any shipping braces (e.g., plugs) must be
removed.
The packaging material must be preserved
until any discrepancies are resolved.
5.1 General information 5.2 Setup and attachment
The product should be protected from
humidity and vibration, and should be
mounted so that it is easily accessible,
allowing all further installation work to be
done without difficulty. Ensure that there is
sufficient air circulation to prevent excessive
heating.
For the maximum permissible ambient
temperature, see "Technical data."
The mounting position of the product is as
shown in the assembly drawing.
To Next Page
Loading...
Need help?
General
