To Next Page

To Previous Page

9. Malfunctions, causes, and remedies

Code Fault notification Fault

[010] Pump Offline Output pump not available

[011] Pump Config Output pump wrong settings

[012] Remote Address Output pump address multiple

[013] LL Sensor Offline Input Low Level not available

[014] LL Sensor Config Input Low Level wrong settings

[015] LL Sensor Address Input Low Level address multiple

[016] LL Sensor Fault Input Low Level sensor: value to high

[017] LL Sensor NC Input Low Level: Open Loop detected

[018] HL Sensor Offline Input High Level: not available

[019] HL Sensor Config Input High Level: wrong settings

[020] HL Address Input High Level: address multiple

[021] LL Output Offline Output Low Level: not available

[022] LL Output Config Output Low Level: wrong settings

[023] LL Output Address Output Low Level: address multiple

[024] EOL Sensor Offline Input sensor at Eol not available

[025] EOL Sensor Config Input sensor at Eol wrong settings

[026] EOL Sensor Address Input sensor at Eol address multiple

[027] EOL Sensor Fault Input sensor at Eol sensor value too high

[028] EOL Sensor NC Input sensor at Eol Open Loop detected

[029] Rel/Cnt Offline Input Rel/Cnt: not available

[030] Rel/Cnt Config Input Rel/Cnt: wrong settings

[031] Rel/Cnt Address Input Rel/Cnt: address multiple

Other manuals for SKF LMC 301 series

Questions and Answers:

Need help?

Do you have a question about the SKF LMC 301 series and is the answer not in the manual?

General