9. Malfunctions, causes, and remedies
EN
85
9
Code Fault notification Fault
[100] Mtr Protection On Motor protection on
[101] Int Temp Offline Input internal temperature: not available
[102] Int Temp Config Input internal temperature: wrong settings
[103] Int Temp Address Input internal temperature: address multiple
[104] Temp Out of Range Temperature out of Range
[105] Ext Temp Offline Input external temperature: not available
[106] Ext Temp Config Input external temperature: wrong settings
[107] Ext Temp Address Input external temperature: address multiple
[108] Ext Temp Fault Input external temperature sensor: value too high
[109] Ext Temp NC Input external temperature: Open Loop detected
[110] Reservoir empty Reservoir empty
[111] Filling Timeout Filling Timeout
[112] Prox Sw .. Offline Input Proximity Switch not available
[113] Prox Sw .. Config Input Proximity Switch wrong settings
[114] Prox Sw .. Address Input Proximity Switch address multiple
[142] Prox Sw .. Timeout Proximity Switch..Monitoring Timeout
[157] Supply ExtIO.. Supply Error at IO Board..:
[158] Int.Supply ExtIO.. I nt e rn al S up pl y E rro r at I O Bo ard : :
[159] Sensorcur. ExtIO.. S e n s o r C u r r e n t S u p p l y E r r o r a t I O B o a r d . .
[160] IO Board . Offline.. IO Board.. offline
[161] General ExtIO.. General Error: at IO Board..
[192] Fill Pump Offline Output Fill Pump: not available
[193] Fill Pump Config Output Fill Pump: wrong settings
[194] Fill Pump Address Output Fill Pump: address multiple