125
PROBLEM CAUSE CONSECUENCES SOLUTION
NON CYCLIC REQ
ERROR
[NON CYCLIC REQUEST
ERROR]
There is a
communication error
between the devices
and it is not possible to
detect the current,
voltage or the i/o status
etc correctly.
The machine does not
work.
Turn the electronic board off
and back on again.
Contact the assistance centre if
the problem continues.
SAVE PRODUCT
SAFETY
The descent of the cross
sealing bar is not
possible.There must be
a product jam.
The machine does not
work.
- Check the product stability.
- check the format parameters
setting.
- check that there isn’t an
obstruction close of the
photocell that blocks the
descent of the sealing bar.
- check the signal of the
photocell 24.B.1.
To Next Page
Loading...
