77
2 - Pack length
• Insert in this field the length of the pack to be wrapped (essential when the MULTIPACK
function is enabled).
• The sealing bar will come into contact with the product if you insert a value that is too low
in relation to the size of the product.
>FILM ADJUSTMENT
This menu is required to adjust parameters relative to tensioning the film.
Use this menu whenever you need to change the format concerned.
1 - Film advance
Indicates the amount of film to be unwound before the pack.
You are advised to first insert the height of the product to be wrapped, and then modify the
configured value according to the size and properties of the film used. In the case of packs less
than 30 mm in height, you are advised to insert a value no less than 30 mm.
If the value you insert is lower than required, the film may protrude beyond the film dragging
wheels. You should configure the parameter also taking into account the subsequent
heatshrinking phase.
Fig. 9.13.10
Fig. 9.13.11
(value from 0 to 600 mm)
ENABLED
PACK
MULTIPACK
Esc
Mod
PACK
PACK LENGHT
[mm]
Esc
Mod
XXX
To Next Page
Loading...
