9 - Operation and use
78
2 - Film advance recovery
Shows the speed at which the pusher moves. Pusher speed can be adjusted in % from 20 to
80. It is recommended to decrease speed when the product is instable.
The parameter can always be displayed but can be configured only in the PROGR 2nd level
menu.
3 - Film delay
Indicates the amount of film to be unwound after detecting the end of the pack.
You are advised to first insert half the height of the product and modify the value (increase it)
only if the seal breaks at the back.
Fig. 9.13.12
FP6000-FP6000CS :
value between 0 and 200 mm
FP8000CS :
value between 0 and 300 mm
Fig. 9.13.13
(value between 0 and 100 mm)
Fig. 9.13.14
FP6000-FP6000CS :
value between 0 and 200 mm
FP8000CS :
value between 0 and 300 mm
XXX
FILM ADJUSTMENT
FILM ADVANCE
(= h PRODUCT)
[mm]
Esc
Mod
FILM ADJUSTMENT
FILM ADVANCED
RECOVERY
[m]
Esc
Mod
XX
FILM ADJUSTMENT
FILM DELAY
(= 1/2 h PRODUCT)
[mm]
Esc
Mod
XXX
To Next Page
Loading...
