Smipack FP6000CS - Page 79

79
4 - Film delay recovery
Use this parameter when the pack is put in too big a bag and the “FILM DELAY” value cannot
be decreased any further. This parameter allows you to move the pack further back on the
conveyor, reducing the size of the bag in the process.
The parameter is particularly useful for when wrapping high packs.
5 - Decrease film tensioning
This parameter allows you to decrease film tensioning when the corner of the seal
breaks.
After adjusting the parameter, check the scale of the reel holder is used once during each
wrapping cycle.
6 - Speed of conveyor belts on machine
Adjusts work speed of the machine motors (infeed belt motor, outfeed belt motor, film pulling
motor, waste recovery motor) affecting wrapping performance.
The speed can be varied in %. The minimum speed that can be set is 10 m/min (corresponding
to 50%).
Fig. 9.13.15
FP6000-FP6000CS :
value between 0 and 200 mm
FP8000CS :
value between 0 and 300 mm
Fig. 9.13.16
(value from 0 to 2 seconds)
FILM ADJUSTMENT
FILM DELAY
RECOVERY
[mm]
Esc
Mod
XXX
FILM ADJUSTMENT
DECREASE
FILM TENSIONING
[s]
Esc
Mod
XXX