9 - Operation and use
80
The maximum speed that can be set may be limited when the machine is installed in continents
where the power supply voltage is different.
These precautions allow the wrapping machine to always be able to operate in optimal
conditions.
The table below indicates the maximum speeds that can be reached by the machine
depending on the configuration of the continent.
To configure the continent in which the machine is installed, proceed as follows:
1) Access the LEVEL 3 menu with the password "TARAT" (see parag. 9.12 - ACCESS TO THE
RESERVED MENUS)
2) Select the menu >CONFIG. PARAMETERS and scroll the sub-menus until the following
screen is displayed:
Fig. 9.13.17
(50 ÷ 150 %)
CONTINENT
CONFIGURATION
MINIMUM ALLOWED
MAINS VOLTAGE
(± 10 %)
MAXIMUM SPEED THAT
CAN BE SET
MAXIMUM SPEED
THAT CAN BE REACHED
EUROPE
230 V 150 % 30 m/min
SOUTH AMERICA
210 V 130 % 26 m/min
NORTH AMERICA
210 V 130 % 26 m/min
AFRICA
220 V 140 % 28 m/min
ASIA
220 V 140 % 28 m/min
OCEANIA
230 V 150 % 30 m/min
FILM ADJUSTMENT
SPEED OF CONVEYORS
Min 10 Max m/min
[%]
Esc
Mod
XXX
To Next Page
Loading...
