81
The selection of the CONTINENT is normally carried out by the manufacturer during test
inspection. However, should malfunctioning occur on the conveyor belts and/or in case of
need, proceed with re-configuration.
>OPTIONS
A number of settings are managed with this menu, allowing you to improve the product
packaging operations.
1 - Conveyor belt management
With this parameter enabled, the connecting belt moves towards the infeed belt immediately
after the sealing phase, to facilitate the transfer of particularly short products.
You are advised to use this function only for products between 30 and 80 mm in length, as it
reduces the machine's production rate.
2 - Infeed belt operation management
It is possible to manage the operation of the machine's infeed belt by choosing from the modes
described here below:
- CONTINUOUS : the infeed belt remains in operation until the product is detected by the
machine's photocells.
Fig. 9.13.18
Fig. 9.13.19
CONFIG. PARAMETERS
SELECT
CONTINENT
Esc
Mod
EUROPE
OPTIONS
HANDLING OF
CONVEYOR BELT
Esc
Mod
DISABLED
To Next Page
Loading...
