9 - Operation and use
82
- INTERMITTENT : the infeed belt operates intermittently Using this mode is recommended
only to package products that are lower than 2 cm in height and that are detected by the
vertical photocell.
- In "SOFT START" mode, the infeed belt runs at a more moderate speed. Use soft start mode
in the case of superimposed products and only when the conditions demand it, as this work
mode reduces productivity.
3 - Type of product detection
You can select the type of sensor for detecting the products.
There are three types: HORIZONTAL, VERTICAL and HORIZONTAL+VERTICAL.
In "HORIZONTAL" mode, the packs are detected by the horizontal sensors. These ensure
greatest productivity. This mode is for packs higher than 2 cm.
In "VERTICAL" mode, the packs are detected by the vertical sensors. This mode is for packs
less than 2 cm in height.
In "HORIZONTAL+VERTICAL" mode, the packs are detected by the horizontal and
vertical sensors. You are advised to use this mode only for products of irregular shape
and when the "MULTIPACK" mode cannot be used, and to reduce the machine speed as
appropriate.
Fig. 9.13.20
Fig. 9.13.21
OPTIONS
INFEED BELT
OPERATION
Esc
Mod
CONTINUOUS
OPTIONS
PRODUCT DETECTION
TYPE
Esc
Mod
HORIZONTAL
To Next Page
Loading...
