48
Operating via a web browser within your own network
To perform a connection test a Wireless Package has to be connected to the Solar-Log™, the interface
with the Wireless Package has to be activated in the
Configuration | Devices | Definition menu and the
inverter has to be selected. (See the RS485 Wireless Package Installation Instructions).
Select the interface that the Wireless Package is connected to and press the Start button for the connec-
tion test.
The test is successful when the line goes to 100% percent and remains there.
Note!
Successful data transfers can only be guaranteed when the wireless connection is
permanently at 100%.
Note!
Refer to the Installation Manual for the installation and configuration of the Wire-
less Package.
To Next Page
Loading...
Need help?
General
