Copying and Swapping Data Between Channels
I
t is possible to copy the settings of one channel onto another channel, or to swap the settings of two channels with each other.
To perform either of these functions, press the
>?G&E0?'%0B0 button to produce the following pop-up:
To copy a channel’s settings to another channel, select the channel you want to copy in the left-hand
&>C@24'% column, select
the channel to which you want to copy these settings in the right-hand 4AB8=0B8>='% column, and press >?G.
To swap a channel’s settings with another channel, select one of the channels in the &>C@24'% column and the other in the
4AB8=0B8>='% column, and press &E0?.
Once you have made all of the copies and swaps you need to make, press " to close the pop-up.
Manually reset switches and pots will now need to be reset. Automatically reset switches and faders can now be reset using
either the &4B'%B>;;70=Aor &4B'%B>70=buttons.
Chapter 4 - Matrix Remote
64
Matrix
2
Owner’s Manual
To Next Page
Loading...
Need help?
General
