Safety instructions Spectroquant
®
Pharo 300
34
ba75703e07 04/2014
2.2 Authorized use
The Photometer was developed for use in the laboratory for water analysis.
Follow the technical specifications of the cells in chapter 7 T
ECHNICAL DATA.
Any other use is considered to be unauthorized.
2.3 General safety instructions
The photometer is built and inspected according to the relevant guidelines
and norms for electronic instruments (see chapter 7 T
ECHNICAL DATA). It left
the factory in a safe and secure technical condition.
Note
The opening of the photometer or adjustment and repair work must only be
performed by specialist personnel authorized by the manufacturer. Noncom-
pliance invalidates any claim with regard to the warranty.
Function and
operational safety
The smooth functioning and operational safety of the photometer can only be
guaranteed if the generally applicable safety measures and the specific
safety instructions in this operating manual are followed during operation.
The smooth functioning and operational safety of the photometer can only be
guaranteed under the environmental conditions that are specified in chapter
7 T
ECHNICAL DATA.
If the photometer was transported from a cold environment to a warm envi-
ronment, the formation of condensate can lead to the faulty functioning of the
meter. In this event, wait until the temperature of the meter reaches room
temperature before putting the meter back into operation.
Safe operation If safe operation is no longer possible, the photometer must be taken out of
operation and secured against inadvertent operation.
Safe operation is no longer possible if the photometer:
has been damaged in transport
has been stored under adverse conditions for a lengthy period of time
is visibly damaged
no longer operates as described in this manual.
If you are in any doubt, contact the supplier of your photometer.
To Next Page
Loading...