Spectroquant Pharo 300 - Initial Commissioning; Inserting the Buffer Batteries

Spectroquant
®
Pharo 300 Commissioning
39
ba75703e07 04/2014
3.3 Initial commissioning
Perform the following activities:
 Insert the buffer batteries (see section 3.3.1)
 Connect the power supply (see section 3.3.2)
 Switch on the photometer (see section 3.3.3)
 Set the language (see section 3.3.4)
 Set the date and time (see section 3.3.5)
 Carry out a zero adjustment (see section 4.4)
Note
When you set the language, date and time according to the mentioned sec-
tions of this operating manual you will quickly become familiar with the simple
operation of the Spectroquant
®
Pharo 300. More detailed instructions on
operation are given in section 4.2 G
ENERAL OPERATING PRINCIPLES.
3.3.1 Inserting the buffer batteries
The buffer batteries supply the integrated clock while the photometer is
switched off. Four alkaline manganese batteries (type AA or Mignon) sepa-
rately included in the scope of delivery are used as the buffer batteries.
Insert the batteries as follows:
Battery service life The power consumption of the clock is very low. The lifetime of high quality
batteries is at least 5 years.
1 Turn the photometer upside down
and place it on a soft surface.
2 Open the lid of the battery com-
partment (1).
3 Insert the four batteries in the bat-
tery compartment. Make sure that
the poles of the batteries are in the
correct position.
The ± signs on the batteries must
correspond to the ± signs in the
battery compartment.
4 Close the lid of the battery com-
partment.
1