Spectroquant Pharo 300 - Saving Measurement Datasets Automatically; Saving Measurement Datasets Manually

Spectroquant
®
Pharo 300 Operation
145
ba75703d07 04/2014
4.11.5 Saving measurement datasets automatically
For the measuring modes, Concentration, Absorbance / % Transmission,
and Special / Multi wavelengths you can record every measured value auto-
matically (AutoStore).
All automatically stored measurement datasets are given the ID "AutoStore".
The "AutoStore" ID is overwritten if the same measured value is manually
stored afterwards (<STORE>).
This ensures that every measurement dataset is stored in the data memory
only once.
Activating
AutoStore
Activate the AutoStore function as follows:
Note
The AutoStore setting is valid for all three measuring modes, Concentration,
Absorbance / % Transmission, and Special / Multi wavelengths.
The available functions are dis-
played.
1 Select and confirm AutoStore.
The AutoStore function is active
().
<HOME>
Concentration,
Absorbance / % Transmission, or
Special / Multi wavelengths
– [Setup]
– Measurement data
memory
– Setup