EasyManua.ls Logo

Spectroquant Pharo 300 - Page 434

Default Icon
456 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instructions for the Preparation of Standard Solutions
Standard solution of hydrazine
Preparation of a standard solution:
Dissolve 4.07 g of hydrazinium sulfate GR with oxygen-low (boil pre-
viously) distilled water in a cali brated or conformity-checked 1000-ml
volumetric flask and make up to the mark with oxygen-low distilled
water.
The standard solution pre pared according to this procedure has a
concen tration of 1000 mg/l hydrazine.
Further investigational concentrations may be prepared from this stan-
dard solution by diluting accordingly with oxygen-low distilled water.
Stability:
When stored in a cool place (refrigerator), the standard solution of
1000 mg/l and the diluted standard solutions (investiga tional concen-
trations) remain stable for one day.
Reagents required:
1.04603.0100 Hydrazinium
sulfate GR
for analysis
1.16754.9010 Water for
analysis
EMSURE
®
Release 06/2014
Spectroquant
®
photometers NOVA 60 and Pharo photometers
Reagents required:
1.09122.1000 Potassium
permanganate
solution
0.02 mol/l
Titripur
®
1.07209.0250 Perhydrol
®
30%
for analysis
EMSURE
®
1.00716.1000 Sulfuric acid
25% for analysis
EMSURE
®
1.16754.9010 Water for
analysis
EMSURE
®
Standard solution of hydrogen peroxide
Preparation of a stock solution:
Place 10.0 ml of Perhydrol
®
30% H
2
O
2
in a calibrated or conformity-
checked 100-ml volumetric flask and make up to the mark with distilled
water. Transfer 30.0 ml (full pipette) of this solution to a calibrated or
conformity-checked 1000-ml volumetric flask and make
up to the mark with distilled water.
The stock solution prepared according to this proce dure has a concen-
tration of approx. 1000 mg/l hydrogen peroxide.
Precise assay of the stock solution:
Pipette 50.0 ml (full pipette) of the hydrogen per oxide stock solution into
a 500-ml conical flask, dilute with 200 ml of distilled water, and add
30 ml of sulfuric acid 25%.
Titrate with a 0.02 mol/l potassium permanganate solution until the
color changes to pink.
Calculation and preparation of a standard solution:
Consumption of potassium permanganate solution 0.02 mol/l (ml) x
34.02 = content of hydrogen peroxide, in mg/l
Further investigational concentrations may be prepared from the stock
solution exactly determined according to the procedure described
above by diluting accordingly with distilled water.
Stability:
When stored in a cool place (refrigerator), the stock solution of approx.
1000 mg/l and the diluted standard solutions (investigational concen-
trations) remain stable for one day.

Table of Contents