Stihl MS 362 Manual

122 MS 362, MS 362 C
Installing
During all the following procedures:
: To reduce the risk of a short
circuit, make sure the insulating
tubes completely cover the
connections.
: Push the heating element/wiring
harness wire (1) through the
insulating tube (2).
: Push the heating element/wiring
harness wire (1) through the
insulating tube (2).
165RA267 TG
0001RA390 TG
2
1
0001RA267 TG
2
1
Before placing the wires in position,
make sure they are the same
length.
: Push the pin and socket together
until they lock.
: Push the insulating tube (1) over
the connector.
: Insulating tubes must be located
in the guides (arrows).
: Push the wires fully into the
guides (arrows).
0001RA257 TG
1
0001RA357 TG0001RA476 TG
: Starting from the edge (1), push
the insulating tube (2) into the
guides (arrows).
Make sure the wires are laid neatly
and straight (no loops).
– Install the air guide shroud,
b 12.4
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
0001RA492 TG
1
2

Stihl MS 362 Specifications

General

Displacement	59.0 cm³
Powerhead Weight	5.6 kg
Chain pitch	3/8"
Vibration level (left/right)	3.5/3.5 m/s²
Weight	5.6 kg
Guide Bar Length	40-50 cm (16-20 in)
Oil Capacity	325 cc
Weight (without cutting equipment)	5.6 kg
Oil tank volume	325 cc