77MS 362, MS 362 C
: Push the connector sleeve into
the heater switch (2).
: Push the wire (1) into the guide
(arrow).
: Position the wire (1) so that the
insulating tube (2) is against the
edge of the grommet (arrow).
: Fit the wire in the guide (3).
0001RA263 TG
1
2
0001RA265 TG
2
1
3
: Push the wire into the guides
(arrows).
– Fit the generator wire, b 13.7
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
0001RA355 TG
To Next Page
Loading...
