Starting up the machine
Verti Mix Double K Edition
129
08.08
Fig. 72
1. Completely open the discharge door
through which you want to enter the mixing
container.
2. Secure the tractor and machine against
accidental starting and rolling, see page
126.
5. Unscrew the screwed connections (1)
between protective cover (2) and mixing
container (3).
6. Remove the screwed connection (4) of the
swivel pin and take off the protective cover
(2).
7. Enter and leave the mixing container
carefully through the discharge opening or
the crossover conveyor and the discharge
opening.
3. Strip the PTO drive shaft off the tractor’s
p.t.o. shaft allowing you to manually rotate
the mixing auger via the PTO drive shaft, if
necessary.
4. Rotate the mixing auger such that the
cutting knives are directed away from the
discharge opening.
8. Clean the mixing container carefully before
leaving the mixing container.
9. Ensure that all components, tools etc. are
removed from the mixing container.
10. Fix the protective cover (2) again on the
mixing container according to the
specifications after finishing all necessary
work in the mixing container:
10.1 Swivel the protective cover back.
10.2 Screw the protective cover to the
mixing container.
To Next Page
Loading...
