Strautmann Verti Mix Double K - Product Safety; Operation of the Machine in Accordance with Safety Requirements; Safety Devices and Safeguards; Modifications

Safety instructions
3.3 Product safety
3.3.1 Operation of the machine in accordance with safety requirements
Only one person may operate the machine from the driver's
compartment on the tractor, and there must be no-one in the danger
zone of the machine. Please observe here the section "Danger area
and danger spots", on page 20.
3.3.2 Safety devices and safeguards
• Only operate the machine, when all the safety and guard devices
are correctly installed and fully functional.
Faulty and dismantled safety devices and safeguards can bring
about to dangerous situations.
• Please check all safety and guard devices for outward signs of
damage and performance reliability before putting the machine
into operation.
3.3.3 Modifications
• Vehicles with an official operating permit or fittings and
equipment connected to a vehicle with a valid operating permit
or a licence for driving on the road according to road traffic
regulations must be in the condition stipulated in the permit or
licence.
• Structural modifications, additions or conversions may only be
carried out on the machine, when you are in possession of the
written permission for these from the manufacturer.
• In the case of unauthorised structural modifications, additions or
conversions:
ο the declaration of conformity and the CE-marking of the
machine lose their validity,
ο the licence to operate loses all validity under national and
international regulations.
• Use only genuine parts or modification parts and accessories
allowed by the manufacturer which permit:
ο the declaration of conformity and the CE-marking of the
machine retain their validity,
ο the operating licence under national and international rules
to retain its validity,
ο the faultless functioning of the machine to be guaranteed.
• The manufacturer will not accept liability for damage caused by:
ο unauthorised machine modifications,
ο unauthorised modification parts and accessories,
ο welding and drilling work on load-bearing parts of the
machine.
32
Verti Mix Double K Edition 08.08