Safety instructions
3.2.2 Obligations of the operator
All persons, who have been given a job to do on the machine, are
obliged:
• to acquaint themselves with the machine before starting work,
• to acquaint themselves with the following regulations before
starting work and to observe them during the operation:
ο the national, general valid regulations concerning safety-at-
work, accident prevention and environmental protection,
ο the section in this operating manual on "Basic safety
instructions", page 34,
ο to comply with the section in this operating manual on
"Warning and instruction notices", page 47 and the
warnings and cautions for operation of the machine,
ο to read the sections of this operating manual, which are
important for the execution of his/her work tasks.
If the operator detects a device that is not in a perfectly safe condition,
the said operator must clear the defect immediately. If this task does
not fall within the operator's scope of work or does not have the
relevant training, the operator must report the defect to his superior or
to the operating company.
30
Verti Mix Double K Edition 08.08
To Next Page
Loading...
