Start machine
9.3.3 Fodder discharge via crossover conveyor
Fig. 78
. Make sure that people leave the hazardous
area of the machine.
. Keep animals away from the hazardous
area.
. Switch on the p.t.o. shaft.
. Switch on the crossover conveyor drive in
the desired driving direction.
. Power the mixing auger at the desired
driving speed.
. Slowly open the discharge door (1) via the
hydraulic cylinder (2), until the fodder is
homogeneously coming out of the
discharge opening. The set opening width
of the discharge door is indicated by the
pointer (3) on the scale (4).
. Travel over the feeding table at the desired
travelling speed.
The crossover conveyor speed is
infinitely adjustable in order to vary the
lateral delivery distance (throwing
range) of the fodder next to the fodder
mixing trailer. Observe the information
in the chapter "Setting of conveyor
speed for crossover conveyor /
discharge conveyor for side
discharge", page 73.
1
2
3
4
5
6
7
8. Finish fodder discharge:
8
8
8
.1 Close the discharge door.
.2 Switch off the p.t.o. shaft.
.3 Switch off the crossover conveyor only
when the fodder discharge has been
finished.
148
Verti Mix Double K Edition 08.08
To Next Page
Loading...
