Structure and Functions
Keep strictly to the required operating speed of the straw blower, too
low operating speed may cause blockages.
1. Make sure that people and animals leave the hazardous area of
the machine / the straw blower.
2. Set the switchgear to gear level II (low driving speed of the
mixing auger) if the machine is equipped with a switchgear.
3. Rotate the ejection tower into the desired ejection direction.
4. Switch on the p.t.o. shaft of the tractor.
5. Switch on the straw blower.
6. Speed up the straw blower to operating speed:
• P.t.o. shaft speed 750±100 min
-1
for machine without
switchgear,
• P.t.o. shaft speed 1000±100 min
-1
for machine with
switchgear.
7. Open the discharge door completely.
Ensure to reduce the opening width in case of damp or lumpy
spreading material or a lower blower speed (risk of blockage).
8. Set the desired spreading range / throwing range by lifting or
lowering the ejection hood.
5.4.2 Elimination of blockages
WARNING
Operator’s risk of being drawn in or becoming entangled if the
straw blower starts to run during manual elimination of
blockages / jams!
Secure the tractor and the machine against accidental starting and
rolling before manually eliminating blockages / jams.
WARNING
Risk due to blower wheel continuing to run for a short time!
Wait for the blower wheel to stop completely before unscrewing the
screws (Fig. 39/1) at the blow-out pipe (Fig. 39/2) or removing the
cover (Fig. 39/3).
1. Switch off the p.t.o. shaft of the tractor.
2. Close the discharge door.
3. Secure tractor and machine against accidental starting and
rolling.
4. Wait for the blower wheel to stop completely.
5. Unscrew 3 screws (Fig. 39/1) from the blow-out pipe (Fig. 39/2)
such that the blow-out pipe can be easily rotated around one of
the front screws.
Verti Mix Double K Edition
75
08.08
To Next Page
Loading...
