Safety instructions
3.4.10 Machine maintenance and care
• Carry out the prescribed maintenance and care work on the
machine according to schedule!
• Secure the tractor against accidental starting and rolling before
carrying out maintenance and care work on the machine!
• Mechanical, hydraulic, pneumatic and electric and electronic
residual energy still present can trigger off accidental machine
movement!
Take into consideration the existence of residual energy in the
machine when carrying out maintenance work. Danger signs
signalise component parts with residual energy. Detailed
information can be found in the relevant chapters of this
operating manual.
• Secure all operational media, such as compressed air and
hydraulic oil, against unintentional start-up!
• Attach and secure large assemblies carefully to hoisting units
before replacing them!
• Check nuts and bolts regularly for tight fitting! Retighten loose
nuts and bolts!
• Secure the raised machine and/or raised parts of the machine
against accidental lowering before servicing the machine or
carrying out maintenance!
• Use suitable tools and wear gloves when replacing work tools
with cutting edges!
• Check loosened screws and retighten where necessary. Check
correct functioning of safety and guard devices after completion
of servicing!
• Dispose of oils, greases and filters in the proper manner!
• Handle and dispose of used matter and materials for machine
cleaning in a proper and appropriate manner, in particular:
ο when working on lubricating systems and equipment,
ο when cleaning with solvents!
• Disconnect the cable from the generator and battery on the
tractor before carrying out electric welding on the tractor and / or
mounted / hitched-up machine!
• Replacement parts must comply as a minimum with the technical
requirements laid down by the manufacturer! These are fulfilled i
genuine parts are used!
• Observe the maintenance intervals for parts subject to wear and
tear!
44
Verti Mix Double K Edition 08.08
To Next Page
Loading...
