Start machine
9.3.4 Fodder discharge via conveyor extension
. Make sure that people leave the hazardous
area of the machine.
2. Keep animals away from the hazardous
area.
. Switch on the p.t.o. shaft.
. Switch on the crossover conveyor drive in
the desired driving direction.
. Power the mixing auger at the desired
driving speed.
Fig. 79
1
3. Swivel the conveyor extension (1) to
working position.
4
5
6
7
8
9
9
9.2 Switch off the p.t.o. shaft.
9
10
The conveyor extension drive is
hydraulically coupled with the
crossover conveyor drive. If the
crossover conveyor is not driven in the
conveyor extension’s direction, the
conveyor extension will stop.
. Open the discharge door (2) at the desired
opening width. The set opening width of the
discharge door is indicated by the pointer
(3) on the scale (4).
. Travel over the feeding table at the desired
travelling speed.
The crossover conveyor / conveyor
extension speed is infinitely adjustable
in order to vary the lateral delivery
distance (throwing range) of the
fodder next to the fodder mixing trailer.
Observe the information in the chapter
"Setting of conveyor speed for
crossover conveyor / discharge
conveyor for side discharge", page 73.
. Finish fodder discharge:
.1 Close the discharge door.
.3 Switch off the crossover conveyor only
when the fodder discharge has been
finished.
. Swivel the conveyor extension to transport
position.
Verti Mix Double K Edition
149
08.08
To Next Page
Loading...
